All Weather Surfaces

Acry-Chem Roof Shield is available in 5 gallon pails.

• Premium-Grade Formula
• UL 790 Class A
• Factory Mutual 4470 tested
• Meets ASTM D6083
• Highly Heat Reflective
• Mildew-Resistant
• Applied by Roller or Spray
• Fast Drying and Curing

For Mineral Capsheet / Modified Bitumen:

1. Clean surfaces prior to coating…power washing is best method.
2. Apply 1 coat Acrychem Primer @ 300 sq.ft./gal by roller or pump sprayer.
3. Apply 1^st coat Acrychem Basecoat @ 50 sq.ft./gallon, imbedding polyester fabric into wet coating.
4. Apply 1st coat Acrychem Topcoat @ 75 sq.ft./gallon
5. Apply 2^nd coat Acrychem Topcoat @ 100 sq.ft./gallon

For Metal Roofs:

1. Clean surfaces prior to coating.
2. Spot prime any bare metal or rusted metal with Heavy Duty Metal Primer
3. Install self-adhesive tape over all seams and flashing pieces
4. Install either self adhesive anchor caps or polyurethane sealant over all anchors
5. Apply 2 coats Acrychem Topcoat @ 75 sq.ft/gallon per each coat

For Tar & Gravel Roofs:

1. Remove all loose gravel, dirt, and dust from roof surface.
2. Apply Acrychem Emulsion @ 5 gallons per 100 sq.ft., while wet, imbed 40” fabric into wet coating to fully adhere. Backroll or brush surface with dry roller to press into the emulsion. Do not overcoat fabric on topside with emulsion.
3. After emulsion/fabric is dry, rinse off surface with hose to remove surfactant.
4. Apply 1^st coat Acrychem Topcoat @ 75 sq.ft./gallon
5. Apply 2^nd coat Acrychem Topcoat @ 75 sq.ft./gallon

We typically recommend that you install fabric and coating around all roof penetrations (pipes, vents, skylights, etc.). We also recommend the same over the perimeter flashing to prevent wind uplift. Both of these steps should be done prior to the above installation steps for each type of roof.

Acrychem Roofshield is used to waterproof and protect existing and new roof substrates, including built-up, metal, modified bitumen capsheets, asphalt shingles, and wood roof decks. When installed per manufact urer’s instructions, it is a permanently renewable, totally waterproof, and highly heat reflective roof system. In the standard “White” color, the heat reflectivity is about 85%. This can be extended up to 93% reflectivity by adding an additional coat of our Iradium IR finish. Other colors are available if “White” is not desired, the lighter colors being the better reflectors.

Acrychem Roofshield can be applied by brush, roller, and airless spray equipment. Full material and material/labor warranties are available through licensed applicators that have been trained in the proper application of the system.

Colors:

Acrychem Roofshield can be tinted to a full range of custom colors, from the lightest shades to mid-tone colors. Of course, the “White” color is the most heat reflective. You can select colors from our suggested group or bring in a sample for color matching at our shop.

Colors – Standard Gray, Tan, and White. Custom colors upon request.